Precision Valve & Automation Software
- 1 -
Software
CD ROM
• One (1) CD ROM is included with this manual. It contains the PathMaster
®
software
used to program the Dispensing System via a Windows interface. To install, insert
CD ROM, and click “Install PathMaster® “ NOTE: If you have previously installed
PathMaster®, be sure to uninstall the old version before installing the new version.
• This CD also includes a few helpful tutorials explaining some of the most often used
functions of the PathMaster®
software.
Note: Your PathMaster® CD comes equipped with the ability to produce floppy disks.
On this CD you will find a directory labeled “144MB”. Simply copy the files from each
disk directory to individual floppies for a complete set of installation floppy disks.
Floppy Disk(s)
• One (1) floppy disk is included with this manual. It contains a backup copy of the
main program xxxx_m01.txt, where xxxx is the serial number of the machine and m01
is the main program revision. The machine was shipped from Precision Valve &
Automation, Inc. with the original copy of this main program resident in memory. In
certain situations, a PathMaster® project backup file xxxx_p01.bck may also be
included on the floppy disk, where xxxx is the serial number of the machine and p01
is the project file revision.
To prevent unintentional alteration of the files, the disk has been write-protected.
To Previous Page
Loading...