Operation and Maintenance Manual Rev M(ii) 4/03
- 53 -
Solvent Position - The location in the workspace where the head moves to rest in a solvent solution to
maintain the dispense / spray valves when the workcell is not processing product.
Standby Position – The rest position for the end effector. The machine moves here after homing and after
each cycle. This position is usually located near the start point for the program(s). It is NOT the same as
the Home Position.
Terminal – A program used as a communication link between the controller and operator.
Teach – A process by which the workcell registers its current gantry location with PathMaster® to create a
motion sequence.
Workcell – A model PVA250™, PVA550™, PVA750™, PVA1000™, PVA2000™, PVA2000C™ or
PVA3000™ automated system.
To Next Page
Loading...