Operation and Maintenance Manual Rev M(ii) 4/03
- 57 -
ID Description
58 Unrecognized command in a command response (i.e._GNX)
59 Mismatched parentheses
60 Download error - line too long or too many lines
61 Duplicate or bad label
62 Too many labels
65 IN command must have a comma
66 Array space full
67 Too many arrays or variables
71 IN only valid in task #0
80 Record mode already running
81 No array or source specified
82 Undefined array
83 Not a valid number
84 Too many elements
90 Only X Y Z W valid operand
95 TM too large for stepper pulse
96 SM jumper needs to be installed for stepper motor operation
100 Not valid when running ECAM
101 Improper index into ET (must be 0-256)
102 No master axis defined for ECAM
103 Master axis modulus greater than 256*EP value
104 Not valid when axis performing ECAM
105 EB1 command must be given first
118 Controller has GL1600 not GL1800
To Next Page
Loading...