PathMaster® Manual Rev. H 6/03
- 10 -
Solvent Purge – An Auto Purge performed after the valves move from the solvent cups prior to processing
product.
Standby Position – The rest position for the end effector. The machine moves here after homing and after
each cycle. This position is usually located near the start point for the program(s). It is NOT the same as
the Home Position.
Terminal – A program used as a communication link between the controller and operator.
WSDK-1500 – Windows
®
Servo Design Kit 1500. This software is used to setup and tune the servo
system.
To Next Page
Loading...