UPDATING THE FIRMWARE Checking the firmware version
Cubiscan 325 Service Manual 22
process is indicated by asterisks. You must wait until
this process is finished.
16. When the verification process has finished, power
the Cubiscan 325 down.
17. Move the jumper back to the Protected mode.
18. Move the jumper back to the Exec mode.
19. Replace the controller lid and the screws.
20. Slide the center cover back into place and tighten
the thumb screws.
21. Restart the Cubiscan 325.
22. To confirm the new firmware update, see “Checking
the firmware version” below.
Checking the firmware
version
This section describes how to check the version of
firmware that the Cubiscan 325 is using.
1. Go to MENU > About > Version. The Main field
displays which version of firmware is being used.
To Next Page
Loading...
Need help?
General
