Quantronix CUBISCAN 325 User Manual

COMMUNICATIONS PROTOCOL Ethernet (TCP/IP) cable pin assignments
CubiScan 325 Service Manual 49
The following table shows the parameters for asynchronous communications through the RS-232
serial cable.
Ethernet (TCP/IP) cable pin assignments
The Cubiscan 325 Ethernet port uses the 10/100Base-T TCP/IP communications protocol. The
following table shows the Ethernet RJ-45 connector pin assignments.
The following table shows the parameters for the default Ethernet port settings.
The Ethernet port can be configured via this command set or through the touch interface.
Commands exist to configure the Port, IP address, Subnet address and Gateway address.
Asynchronous
communication parameters
Baud Rate 9600
Parity None
Data Bits 8
Start Bits 1
Stop Bits 1
RJ-45 connector pin assignments
Pin Signal Description
1 TD+ Transmit Data
2 TD- Transmit Data
3 RD+ Receive Data
4 NC No Connection
5 NC No Connection
6 RD- Receive Data
7 NC No Connection
8 NC No Connection
Ethernet port (default settings)
IP address DHCP or Static (Default static
10.1.100.100)
IP com port 1050
TFTP port 69

Quantronix CUBISCAN 325 Specifications

General

Brand	Quantronix
Model	CUBISCAN 325
Category	Accessories
Language	English