COMMUNICATIONS PROTOCOL Cubiscan 325 command set
CubiScan 325 Service Manual 53
Build number
This command causes the Cubiscan 325 to report the build number. This is a non-lft function.
Cubiscan 100 compatible measure mode
This data packet is received from the Cubiscan 325 when a gate measurement is completed. It is
backwards compatible with the Cubiscan 100. The Cubiscan must be manually set to Cubiscan
100 compatibility mode.
Pos Len Description Type Range ASCII
Command format
1 1 Start of text Control (STX) 02h
2 1 Build command Alpha (b) 62h
3 1 End of text Control (ETX) 03h
4 1 Carriage return Control (CR) 0Dh
5 1 Line feed Control (LF) 0Ah
Acknowledge format
1 1 Start of text Control (STX) 02h
2 1 Build command Alpha (b) 62h
3 1 Acknowledge Alpha (A) 41h
4 2 Build number Numeric 00-99
6 1 End of text Control (ETX) 03h
7 1 Carriage return Control (CR) 0Dh
8 1 Line feed Control (LF) 0Ah
Negative acknowledge format
1 1 Start of text Control (STX) 02h
2 1 Build command Alpha (b) 62h
3 1 Neg. acknowledge Alpha (N) 4Eh
4 1 End of text Control (ETX) 03h
5 1 Carriage return Control (CR) 0Dh
6 1 Line feed Control (LF) 0Ah
Pos Len Description Type Range ASCII
Command format
1 1 Start of text Control (STX) 02h
2 1 Measure command Alpha (M) 4Dh
3 1 End of text Control (ETX) 03h
To Next Page
Loading...