Quickie Groove - Armrest Angle Adjustment; Arm Pad-Position Adjustment

81
©2006 Sunrise Medical
SEATING SECTION
Complete the following procedures to adjust the angle
of the armrest.
Loosen the outer clamp. (A)1.
Turn the rear, fi ne-tune adjustment screw (B) in 2.
the upper armrest adjustment clamp clockwise
or counter clockwise, depending on the change
needed.
Re-tighten the outer clamp.3.
If this does not provide enough angle adjustment, 4.
it may be necessary to remove the armrest and
reinsert it closer to the desired angle, and then
make any fi ne-tune adjustments.
The arm pad features 2” of horizontal arm pad
adjustment.
Complete the following procedures to adjust the length
of the arm pad:
Loosen the two slot-screws on the underside of •
the arm pad(Fig 3.35).
Slide the arm pad to the desired position(Fig •
3.36) and retighten.
Armrest Angle Adjustment
Arm Pad-Position Adjustment
A
B
Fig 3.33
Fig 3.34
Fig 3.35