Kiaro! 200 User Guide 1
1
Quick Start Guide
Before Installing the Printer
Choosing an Installation Location
The installation environment must be as described in this section.
• The printer power cord must be able to connect to an outlet (100-240 VAC 50-60
Hz 3.5A). This outlet must be easily accessible.
• Avoid installing the printer near a faucet, water heater, humidifier, or refrigerator.
• Ensure the environment temperature is within 59 to 86 degrees Fahrenheit (15 to
30 degrees Celsius).
• Ensure the environment humidity is within 10% to 90% relative humidity.
• Avoid installing printer near fire, in a dusty place, or in a place where ammonia gas
is generated. When installing printer in a place exposed to direct sunlight, it is
recommended that curtains be hung over the window.
• No printer feet should float. The printer must be held level constantly.
• When placing the printer on a desk, table, or other similar surface, it must be sturdy
and stable enough to support the weight of the printer.
• The room must be properly ventilated.
• Install printer at least 3.5 inches (88.9 mm) away from each wall with a sufficient
work space around it.
To Next Page
Loading...
