Quick Start Guide
Kiaro! 200 User Guide 13
Installing the Printer Driver (USB)
Use the following instructions to install the printer via USB 2.0 on Windows XP,
Windows Vista, Windows 7, or Windows 8.
Note: When the Windows logo testing, publisher verification, or digital signing warning
messages appear, choose to continue the installation. These messages indicate that
the driver has not been “logo tested” by Microsoft. However, it has been tested
thoroughly by QuickLabel, and will not cause any of the problems listed in these
messages.
1 Ensure the Kiaro! 200 is powered on but not connected to your computer via the
USB cable.
2 Power on your computer and insert the Kiaro! 200 Installer CD in the CD drive. The
Installer CD wizard will open. Choose Next.
Note: If the autorun program does not start automatically, use Windows Explorer
to launch the “Setup.exe” file located in the root level of the CD.
3 Use the driver installation wizard to install the driver. Refer to the following
information during this process.
• Choose the USB connection method when prompted.
• Select an installation location for the Kiaro! 200 Maintenance Utility when
prompted.
Choose Finish in the installation wizard after successfully installing the Kiaro! 200
Maintenance Utility and driver.
4 Connect the smaller end of the USB cable to the Kiaro! 200 USB type B port.
Connect the larger end of the USB cable to an available USB 2.0 port on your
computer.
5 Once the USB connection is made, the Windows Found New Hardware Wizard will
start. This wizard will guide you through the rest of the installation process. Refer
to the following general guidelines when using this wizard.
• If you are prompted to connect to Windows Update to search for software,
choose no.
To Next Page
Loading...
Need help?
General
