Kiaro! 200 Maintenance Utility
80 Kiaro! 200 User Guide
Note: Before adjusting the top-of-form threshold, verify that your media has been
loaded and configured correctly.
If you have already adjusted the top-of-form threshold for your reflective mark media,
and you are replacing a reflective mark media roll with an identical roll, repeating this
adjustment is not necessary.
1 Launch the Kiaro! 200 Maintenance Utility.
From the Windows Start Menu, choose Start > All Programs > QuickLabel
Kiaro! 200 > Kiaro! 200 Maintenance Utility. A language and printer prompt will
open.
Select a display language and the Kiaro! 200 printer you want to connect to.
Choose OK.
2 Choose the Adjustments tab.
3 Choose TOF Threshold Adjustment. The Threshold Adjustment window will
open.
4 To read the internal sensor value from the printer and set the Internal Sensor
control accordingly, choose Read From Printer.
5 Enter an adjustment based on the error message table above.
6 Choose Write to Printer. The threshold settings will be saved.
Related Topics:
- Turning On Auto-Calibration on page 81
130C Paper jam occurred Increase NA +0.2V
1402 Gap/Mark width error Decrease NA -0.2V
1403 Gap/Mark width error Increase NA +0.2V
Error # Error Name
Sensor Adjustment
Adjust-
ment ValueInternal Cutter
To Next Page
Loading...
Need help?
General
