Chapter 2 | Getting Started
To get started with video calls and videoconferences, activate the product and use the quick setup wizard to
configure the basic settings of the unit. We recommend following the workflow described in Initial Workflow for XT
Series Users on page 13.
Navigation
•
Initial Workflow for XT Series Users on page 13
•
How to Control the XT Series on page 14
•
Performing Basic Configuration on page 22
Initial Workflow for XT Series Users
About this task
To quickly get started with your XT Series, follow the steps in this workflow.
Before you begin
Your system administrator should install and activate your XT Series. For details, see the following
documentation:
•
Quick Setup Guide for Scopia XT Series: Explains the simplest configuration necessary for the
system to work properly.
•
Safety Instructions leaflet for Scopia XT Series
•
Installation Guide for Scopia XT Series
Your system administrator may have customized certain features described in this guide to suit the
environment of your company.
Procedure
1.
Turn on the XT Codec Unit by pressing the
Power key on the XT Remote Control Unit.
2. Configure the basic settings required to start using the XT Series, as described in Performing
Basic Configuration on page 22.
For details on how to use the XT Remote Control Unit and access both the endpoint interface
and the web interface, see How to Control the XT Series on page 14.
3. You can now make point-to-point video calls and videoconferences, as described in Starting
a Videoconference on page 32.
User Guide for Scopia XT5000 Series Version 3.2 Getting Started | 13
To Next Page
Loading...
