RADVision Scopia XT5000 Series - Remotely Setting the System Name and Language

Important:
If the gatekeeper is configured to be automatically detected by endpoints, select
Automatic (depends on the type of gatekeeper). Consult the network administrator.
3. Enter the IP address of the gatekeeper in the Gatekeeper IP address field.
4. Enter the H.323 number required to dial the XT Codec Unit in the E.164 field.
5. Select Done.
The basic configuration of your Scopia XT Series is complete.
Remotely Setting the System Name and Language
About this task
This procedure describes how to set the name and language of the endpoint from the web interface. You
can also do this as part of the quick setup from the endpoint itself, as described in
Setting the System
Name and Language on page 24.
You can also configure the endpoint to use alternate system name, such as the SIP username, on both
the titlebar and on the monitors participating in the videoconference call, as described in Administrator
Guide for Scopia XT Series.
Procedure
1. Access the name and language settings:
•
From the XT Series web interface, select Basic Settings > Preferences > General.
•
From the endpoint's main menu, select Configure > General.
User Guide for Scopia XT5000 Series Version 3.2 Getting Started | 30