Radwin WinLink 1000 - Figure 3-3: Idu-R Rear Panel; Figure 3-4: Typical Idu-C F

Connecting the ODU to the IDU
WinLink User and Installation Guide Version 1.750 3-38
the O-PoE or PoE-8 cable is 100m (328 ft) in accordance with
10/100BaseT standards.
The ODU-IDU cable is supplied pre-assembled with RJ-45 connectors,
at the length specified when ordering. If the ODU-IDU cable was not
ordered, use Cat. 5e 24AWG shielded cable. Wiring specifications are
given in Appendix A: Wiring Specifications.
To connect the ODU to the IDU
1. Route
the cable from the ODU to the IDU.
2. Secure the cable along its path.
3. Connect the ODU-IDU cable to the RJ-45 connector on the IDU.
The figures below illustrate typical IDU panels. You may have
differences in your panels depending on the hardware ordered.
Figure 3-2: Typical IDU-E Rear Panel
Figure 3-3: IDU-R Rear Panel
Figure 3-4: Typical IDU-C Front Panel
Figure 3-5: AIND All Indoor Radio Unit