Chapter 4
Getting Started
This section provides the following information for WinLink:
• Turning the system on and off
• Starting the WinLink™ Manager software
• Controls and indicators
• Normal Indications
• Default settings
• Technical Specifications
Turning On WinLink
Æ To turn on WinLink:
• Connect the AC/DC converter to the IDU power connector and
to the mains. See Connecting Power to an IDU for full
instructi
ons on connecting the power.
The PWR indicator lights up (IDU-E only) and remains lit as
long as the IDU is receiving power.
Controls and Indicators
WinLink requires no operator attention once installed, with the
exception of occasional monitoring of front panel indicators and
statistics data. Intervention is only required when WinLink must be
configured to its operational requirements, or diagnostic tests are
performed.
IDU Front Panel Indicators
The front panel of the IDU-C and IDU-E includes a series of LED
indicators that show the operating status of the unit.
The following figure shows the IDU-E front panel:
To Next Page
Loading...
