Selecting Channels
WinLink User and Installation Guide Version 1.750 3-48
When changing the channel bandwidth, the WinLink Manager
repeats evaluation of the link.
3. Click the check box if Automatic Channel Selection is required.
4. Click the check boxes in the Available Channels List of all the
allowable channels that can be automatically selected.
Selecting a new channel causes the system quality to change. The
quality bar shows the adjustment until the system finds the best
quality link.
Quality
Service
0.1% – 0.4% 80-99% TDM + Ethernet
0.4% – 2.0% 77- 56% Ethernet
2.0% – 50.0% 44 - 2%
Antenna Alignment or replace
Channel
5. If you are not satisfied with the channel that is selected
automatically, click Reselect Channel.
A new channel is selected from one of the Available Channels that
has been defined.
6. Click Next.
The Evaluating Rate box appears. When the optimum rate for the
link is selected the Service Parameters dialog box opens. Skip to
page 3-51 to set the Service parameters.
Note:
Any changes to the frequency settings cause the link to re-synchronize.
A short loss of service will occur during re-synchronization.
WinLink 5.4 GHz ETSI Version
In accordance with ETSI, if WinLink detects Radar interference it
changes the frequency channel automatically. This feature is termed
Dynamic Frequency Selection (DFS). In this version, the Automatic
Channel Selection is selected by default and a minimum of two
channels must be defined as available.
1. Select the main frequency from the Operating Channel menu.
2. Select the Bandwidth required.
6.
Note:
Automatic Channel Selection is selected by default.
To Next Page
Loading...
