Installation Sequence
WinLink User and Installation Guide Version 1.750 3-33
Installation Sequence
The following steps are required to install the WinLink system:
1. Install the management program on the network management
station/laptop. See Installing the WinLink Management Software,
page 3-35.
2. Moun
t the ODU at each site (and antenna if external antenna is
used). See Mounting the ODU, page 3-36.
3. Conn
ect the ODU to the IDU at both sites. See page 3-37.
4. Conn
ecting the Ground to the IDU, IDU-C, PoE-8, page 3-39.
5. Conn
ect the power. See Connecting Power to an IDU, page 3-39,
and Connecting Power to an O-PoE, page 3-40
6. Align th
e ODU/antennas. See page 3-40.
7. Run th
e Installation wizard from the management program. See 3-
42.
8. Conn
ect user equipment to the local and remote IDUs. See page 3-
45.
To Next Page
Loading...
