Link Configuration Wizard
WinLink User and Installation Guide Version 1.750 5-75
BRS Version: Configuring BRS Channel Settings
Note:
Both sites in a BRS Link must be configured identically.
Æ To Configure BRS Channel Settings
1. Select the Band Plan: Pre-Transition or Post-Transition.
2. Select the Bandwidth required.
• Single Band (5MHz)
• Double Band (10MHz)
• Quad Band (20MHz)
3. Select the Frequency.
4. Click Next. The system is re-synchronized to the changes.
Figure
5-5: BRS Channel Settings Post-Transition
To Next Page
Loading...
