Radwin WinLink 1000 - Selecting Channels; Winlink 1000 with Automatic Channel Select; Figure 3-13: Channels

Selecting Channels
WinLink systems later than version 1.300 have a feature called
Automatic Channel Select, which allows you to define several
alternative frequency channels if interference is detected on the
channel in use.
Note: For the ETSI version, skip to page 3-48; for the BRS version,
skip to pa
ge 3-49.
WinLink™ 1000 with Automatic Channel Select
Automatic Channel Select (ACS) gives WinLink the ability to change
frequency channels automatically if interference is detected on the
current operating channel.
Figure 3-13: Channel Select dialog box - Automatic Channel Select
1. Select the main frequency from the Installation Channel menu.
2. Select the required Channel Bandwidth 5, 10, or 20 MHz. Default is
20 MHz.