Radwin WinLink 1000 - Setting the T1 Line Code; Figure 3-16: Tdm P

Setting the T1 Line Code
WinLink User and Installation Guide Version 1.750 3-54
Figure 3-16: TDM Parameters dialog box
9.
Note:
This dialog box is available with IDU-E and IDU-C units; it is activated
after TDM service is chosen in the previous Service dialog box. In
Ethernet only services, the TDM dialog box does not appear.
Setting the T1 Line Code
The T1 line code can be set as B8Zs or AMI in the TDM Parameters
dialog box.
The default is B8ZS.
Æ To change the line code
• In the TDM Parameters dialog box, set the line code to B8ZS or
AMI.