Rasilient PixelStor 5000 - Connecting a Terminal to Access the CLI

Hardware Installation
PixelStor 5000 User Manual
Rev. 1, May 2013
7-94
7.6 Index of CLI Commands
The following table lists the PixelStor 5000 commands available through the command
line interface.
command
description
daacl
used to manage access control list
daaddrbk
used to add email address to notification list
dacomment
used to add comments to configuration
daconnstat
used to display connection statistics
dadate
used to display or set time and date
dadg
used to manage Disk Groups
dadiskload
download firmware for Seagate hard drives
dadsktst
measure disk baseline IO performance
dafwdwnld
used to download expander firmware
dahelp
used to display information about commands
dahost
used to define and manage host
dahostname
allows user to set the name of the storage array
dahwstat
used to display hardware status
dainspread
used to manage Inspection Read
daisns
used to manage isns registration
dakem
used to display the event log
dalun
used to manage the lun masking table
dantpdate
used to configure an NTP server
dapasswd
used to change the user password
daphyinfo
get expander phy status information
dapm
configure the drive power management
dareboot
used to reboot the local or remote controller
daroute
used to display or set the gateway address
dasavelog
saves the log file to the /pub/ directory
daselblk
select a chassis or a hard drive to blink
dasetup
used to set IP addresses, netmask, gateway and
name server
dashutdown
used to shutdown the local or remote controller
dasmartinfo
used to view disk smart information
dasnmp
used to manage snmp groups
dastat
used to display system information
dastonith
used to forcibly reboot the remote controller