Rasilient PixelStor 5000 - Dastat; Dastonith

Hardware Installation
PixelStor 5000 User Manual
Rev. 1, May 2013
7-120
dasnmp - Add/Delete SNMP managers to send traps to.
Usage:
dasnmp [Options]
Options:
-h/--help: help
-L/--list: list all SNMP managers
-a/--add [address]: add a SNMP manager with/without community
-d/--delete [address]: delete a SNMP manager
-c [community string]: community string of a SNMP manager
-i/--inform [0, 1]: set to informed(1) or non-informed(0) SNMP trap
Option Requirements:
option c requires: a
Command Examples:
dasnmp -a 192.168.1.1: add a SNMP manager without community
dasnmp -a 10.0.0.1 -c pub: add a SNMP manager with community "pub"
dasnmp -d 10.0.0.1: delete a SNMP manager
dasnmp -i 1: set to informed SNMP trap
7.7.32 dastat
Use dastat to display status information for the local controller.
dastat - display the system information.
Usage:
dastat
dastat -help
7.7.33 dastonith
Use dastonith to force a reboot on the remote controller. Make sure a “dastonith 0”
command is executed soon after the “dastonith 1” command, otherwise the remote
controller will not reboot.
dastonith - force reboot of remote controller