Hardware Installation
PixelStor 5000 User Manual
Rev. 1, May 2013
dalun -d -n host1 -g dg1 -k vd1:
un-present virtual disk vd1 in disk group dg1
from host1.
dalun -d -n host2 -g dg1 -k snap1 -P vd1:
un-present snapshot snap1 of virtual disk vd1
in disk group dg1 from host2
7.7.20 dantpdate
Use dantpdate to configure an NTP server.
dantpdate - Configure NTP servers
Usage:
dantpdate [Options]
Options:
-help help
-list list current NTP servers
-add hostName/IPAddress add a NTP server to list
-del hostName/IPAddress delete a NTP server from list
-sync synchronize the system clock on both
controllers with the NTP server
Command Examples:
dantpdate -help display this help page
dantpdate -list list current list of NTP servers
dantpdate -sync synchorinize the system clock on both
controllers with the NTP server
dantpdate -add myntpserver add myntpserver to the list of NTP servers
dantpdate -del 65.78.1.1 delete 65.78.1.1 from the list of NTP servers
7.7.21 dapasswd
Use dapasswd to change the passwords on the system.
To Next Page
Loading...