Hardware Installation
PixelStor 5000 User Manual
Rev. 1, May 2013
load [1-3]. Where High is 1, Medium is 2, Low is 3.
The default priority is low unless otherwise specified.
-duration [hours]: The maximum of hours to run [1 - 10000]. Inspection Read
will stop after running for the specified number of hours.
-add: Add a new schedule or change the current schedule.
-del: Delete the current schedule.
-sch_resume: Schedule Inspection Read to resume from last inspected
block.
-day [Day]: Used to specify the day of week to start Inspection Read
[0 - 6], where 0 specifies Sunday.
-hour [hour]: Specifies the hour to start Inspection Read [0 - 23],
where 0 specifies midnight.
Option Requirements:
start: repeat, cpu and duration are optional.
stop: no parameters should be specified with stop.
resume: repeat, cpu and duration are optional.
schedule: add or del required. If add, then day and hour are
required. sch_resume, repeat, cpu and duration are
optional. If del, then no other parameters should be
specified.
progress: no parameters should be specified with progress.
Examples:
1. dainspread -start
Start Inspection Read.
2. dainspread -start -repeat
Start Inspection Read and run continuously until dainspread is issued
with the -stop option.
3. dainspread -start -repeat -cpu 2 -duration 6
Start Inspection Read at a medium priority and repeat until 6 hours have
passed.
4. dainspread -stop
Stop Inspection Read
5. dainspread -resume
Resume Inspection Read from the last inspected block.
6. dainspread -resume -cpu 1
Resume Inspection Read from the last inspected block at a high priority.
7. dainspread -resume -repeat -cpu 2 -duration 6
Resume Inspection Read at a medium priority and repeat until Inspection
To Next Page
Loading...