Rational iCombi Pro - Placing Tickets

10 | iProductionManager
78 / 188 Original instructions for use
> The timer will be placed at the current time.
2. To place a timer in the future, drag the timer to the start time and rack level of
your choice.
3. To move the timer to a different rack level or change its start time, press and
hold the timer.
4. Drag the timer to the correct position.
5. To increase or decrease timer length, tap the timer briefly,
6. and then either rotate the selection dial or press these buttons: Or
> After a brief waiting period, your new settings will be applied.
>> When the timer goes off, you will be prompted to unload the cooking
system. This symbol will appear beside the rack level: . The cooking time is
at 00:00.
10.4 Placing tickets
a You have created manual tickets [}74], shopping carts [}75] or a ticket
board [}76].
1. Drag a ticket to the desired rack level.
> For better orientation, the rack level you are placing the ticket on will be
highlighted in blue. The time will also be displayed on the ticket as an
additional aid.
> If the rack level is marked in yellow or red, it means that you cannot place the
ticket without moving tickets that have already been placed. More
information is available here: Combination check [}79] and placement logic
[}79]
2. If you have placed multiple tickets, scale the time axis back to a summary
view. To do so, press this button:
The following options are available to optimize the positioning of the tickets:
n
Close planning gaps [}80]
n
Time optimization [}81]
n
Energy optimization [}82]
n
Target time cooking [}84]
If you place tickets for the actual time, a vertical yellow or blue bar will appear:
n
A yellow bar indicates that the cooking cabinet is heating up.
n
A blue bar indicates that the cooking cabinet is being cooled down with the
Cool Down function.
n
The width of the bar indicates how long the heating or cooling will take.