Entering the working speed:
u
Access the menu Fertiliser settings > Start calibration.
u
Enter the average working speed.
This value is required for calculation of the metering slide position during calibration.
u
Press the Enter key.
The new value is saved.
The Approach drop point Yes = Start alarm message appears in the display (AXIS only).
CAUTION!
Risk of injury due to automatic adjustment of the drop point
When the Start/Stop function key is pressed, the drop point is automatically moved to the
preset value by an electrical actuator (Speedservo). This may cause injury.
▶
Before pressing the Start/Stop key, ensure that nobody is present in the hazard zone of
the machine.
▶
Acknowledge the “Approach drop point” alarm message by pressing Start/Stop.
u
Press the Start/Stop key.
The drop point is activated.
The alarm is cleared.
The second calibration page is displayed.
u
Set the spreader side on which the calibration is to be carried out.
Press the key to select the left spreading side, or
Press the key to select the right spreading side.
The icon indicating the selected spreading side has a red background.
WARNING!
Risk of injury during calibration
Rotating machine parts and discharged fertilizer could cause injury.
▶
Before starting the calibration, ensure that all requirements have been met.
▶
Observe the calibration chapter in the operator’s manual for the machine.
4. Operation
50
5902662 QUANTRON-A AXIS/MDS
To Next Page
Loading...
Need help?
General
