If you want to observe the time until the next idle measurement, you can also assign the freely
selectable display fields in the operating screen with idle time, see 4.10.2 Display configuration
When starting the spreading disc, changing the PTO speed, and changing the spreading disc type,
a new idle measurement is mandatory!
In the case of unusual changes in the flow factor, start the idle measurement manually.
Requirement:
• The spreading work has been stopped (Start/Stop key or both sections deactivated).
• The operating screen is displayed.
• The minimum PTO speed is 360 rpm.
u
Press the Enter key.
The Idle measurement screen is displayed.
The idle measurement is started.
u
Adjust PTO speed if necessary.
The bar displays the progress.
5.5 Spreading with the AUTO km/h operating mode
In AUTO km/h operating mode, the control unit automatically controls the actuator depending on the
speed signal.
u
Fertilizer configuration:
w
Appl. rate (kg/ha)
w
Working width (m)
u
Fill the hopper with fertilizer.
In order to achieve an optimum spreading result in the AUTO km/h operating mode, a calibration
should be carried out before starting spreading.
u
Carry out a calibration to determine the flow factor
or
Take the flow factor from the fertilizer chart and manually enter the flow factor.
u
Press Start/Stop.
The spreading starts.
5. Spreading operation
96
5902662 QUANTRON-A AXIS/MDS
To Next Page
Loading...
Need help?
General
