The boundary spreading function is also possible in automatic mode with GPS Control. The
boundary spreading side must be manually operated at all times.
• See 5.8 GPS control
5.4 Spreading with the automatic operating mode (AUTO km/
h + AUTO kg)
Mass flow control with the function M EMC
The mass flow is measured separately on both spreader disc sides in order to be able to immediately
correct any deviations from the specified application rate.
The M EMC function requires the following machine data for mass flow control:
• PTO speed
• Disc type
A PTO speed between 360 and 390 rpm is possible.
• The desired speed should remain constant during spreading (+/ 10 rpm). This gives you a
higher quality of control.
• Idle measurement is only possible if the actual PTO speed deviates by no more than +/- 10 rpm
from the input in the PTO menu. Outside of the range, idle measurement is impossible.
Requirements for spreading:
• The AUTO km/h + AUTO kg operating mode is active. (See 4.7.2 AUTO/MAN mode)
5. Spreading operation
94
5902662 QUANTRON-A AXIS/MDS
To Next Page
Loading...
