Rauch QUANTRON User Manual

u
Press the F4 function key (100 m AUTO, [4])
The calibration run operating screen is displayed.
Fig. 33: Calibration run speed signal operating screen
[1] Pulse display
[2] Start recording pulses
[3] Stop recording pulses
u
Press the F4 function key [2] at the starting position of the reference distance.
The pulse display is now zero.
The control unit is ready for counting pulses.
u
Drive along the 100 m long reference distance.
u
Stop the tractor at the end of the reference distance.
u
Press the F1 [3] function key.
The display shows the number of received pulses.
u
Press the Enter key.
The new pulse count is saved.
The calibration menu is displayed again.
4.7.2 AUTO/MAN mode
The machine control unit automatically adjusts the dosing quantity according to the speed signal. This
adjustment is influenced by the application rate, working width, and flow factor.
By default, the unit is operated in the automatic mode.
You only work in manual mode in the following cases:
• If there is no speed signal (radar or wheel sensor not available or defective)
• Application of slug pellets or seeds (fine seeds)
4. Operation
62
5902662 QUANTRON-A AXIS/MDS

Rauch QUANTRON Specifications

General

Brand	Rauch
Model	QUANTRON
Category	Control Unit
Language	English