On this page, you can manually adjust the parameters. See chapter 5.8 GPS control.
Changing the values
u
Open the desired list entry.
u
Enter the new values.
u
Press the Accept values button.
The OptiPoint has been calculated.
The machine control unit switches to the GPS Control Info window.
4.6.10 GPS Control info
The GPS-Control info menu informs you of the calculated setting values in the Calculate OptiPoint
menu.
Depending on the terminal used, the display will show 2 distances (CCI, Müller Elektronik) or 1
distance and 2 time values (John Deere, etc.).
• With most ISOBUS terminals, the values displayed here are applied automatically to the
corresponding settings menu of the GPS terminal.
• With some terminals, however, a manual entry is required.
This menu is for information purposes only.
• See the operating manual for your GPS terminal.
4.6.11 Fertilizer charts
In this menu, you can create and manage your own fertilizer charts.
Selecting a fertilizer chart has an effect on the fertilizer settings, the machine control unit and the
mineral fertilizer spreader. The set application rate is overwritten by the stored value from the
fertilizer chart.
You will be able to automatically manage fertilizer charts and transfer them from your control unit.
You need a WiFi module (special equipment) and a smartphone to do this. See 2.7 WIFI module
You can create up to 30 fertilizer charts in the electronic machine control unit.
4. Operation
QUANTRON-A AXIS/MDS 5902662
55
To Next Page
Loading...
Need help?
General
