Chapter 3: Operation 3-3
ii. Place the cursor in the required position on the chart and press
ENTER to place the waypoint. The waypoint is added to the way-
point list and named using the next available number.
The waypoint functions remain displayed so that further way-
points can be placed.
If required, use
EDIT WAYPOINT to name the waypoint as described
in Editing Waypoint Details on page 3-5.
iii.When finished placing waypoints, press
CLEAR.
4. To place a waypoint at the vessel’s position:
Select
PLACE WPT AT VESSEL. A new waypoint is placed at the ves-
sel’s current position.
5. To place a waypoint using the Waypoint List:
Select
WAYPOINT LIST. The Waypoint List and associated function
Soft Keys are displayed (Figure 3-4):
Figure 3-4: Waypoint List Display
6. Select MAKE NEW WAYPOINT.
The waypoint is placed at the current vessel position or, if a GPS fix is
not available, the cursor position. The new waypoint is added to the
Waypoint List and named with the next available number.
To return to chart mode, press
CLEAR twice.
SIM NU
D4991_2