Gilat Satellite Networks | Confidential and Proprietary Information | 45
Appendix E – Configuring and
Operating the Antenna with ACU
An ACU is needed to configure and operate the antenna.
You can use either the ACU web interface or LCD configuration options to configure
the ACU to operate and control the antenna and to verify proper operations.
Entering the configuration mode and changing parameters should
only be done by a qualified technician after reading this document.
The user interface sometimes refers to the ACU as IDU or Indoor
Unit. In this manual, IDU generally refers to any system component
that is installed indoors.
The following sections describe how to connect, configure, and operate the ACU for
two-way satellite data communications.
ACU Controls, on page 46
Operating the ACU, on page 48
Operating the Antenna with the ACU, on page 48
Configuring the Antenna with the ACU, on page 48
To Next Page
Loading...