PG-FP5 CHAPTER 4 PROGRAMMING GUI USAGE
R20UT0008EJ0400 Rev. 4.00 Page 85 of 240
Jul 15, 2010
Figure 4-57. [Download file] Dialog Box
<5> [Information] area and Clear button
This area displays a warning message or is used to clear information on PR5 files, ESF files and program files.
Figure 4-58. [Information] Area and Clear Button
[Information] area
A warning message will be displayed in this area if there is a mismatch between PR5 files, ESF files and program
files saved in the FP5 and information held in the programming GUI.
Clear button
Information of PR5 files, ESF files and program files, which is set to the current valid programming area, can be
deleted .
Information of a programming area that is no longer required to be used can be deleted. When the clear button is
clicked, deletion of the set information selected in the programming area settings will be specified.
When the OK button is clicked, programming areas that are currently valid will be downloaded and the internal
memory information of the programming area, for which deletion has been specified by using the clear button, will
be deleted. Deleting the information of all programming areas cannot be performed.
Initialize the FP5 management setting to initialize all programming areas. See the [FP5 Management setting (M)
…] command in 4.3.2 (9) [FP5 Manager] command for details.
Caution The settings are not reflected to the FP5 internal memory unless the OK button is clicked in
the Device Setup dialog box.
To Next Page
Loading...
Need help?
General
