PG-FP5 CHAPTER 4 PROGRAMMING GUI USAGE
R20UT0008EJ0400 Rev. 4.00 Page 87 of 240
Jul 15, 2010
(b) [Standard] tab in Device Setup dialog box
On the [Standard] tab, set the programming environment of the flash memory in the target device. All basic
settings to configure the user environment and the target device can be performed. Communication channels,
speeds and the operation clock supplied to the target device vary depending on the device, so refer to the user’s
manual of the target device for setting these items.
This tab consists of the following items.
<1> [Communication interface to device] area
<2> [Supply oscillator] area
<3> [Operation Mode] area
<4> Defaults button
Figure 4-60. Device Setup Dialog Box - [Standard] Tab
<1>
<3>
<2>
<4>
To Next Page
Loading...
