RL78/G13 CHAPTER 24 OPTION BYTE
R01UH0146EJ0100 Rev.1.00 922
Sep 22, 2011
(3) 000C2H/010C2H
{ Setting of flash operation mode
• LV (low voltage main) mode
• LS (low speed main) mode
• HS (high speed main) mode
{ Setting of the frequency of the high-speed on-chip oscillator
• Select from 1 MHz, 4 MHz, 8 MHz, 12 MHz, 16 MHz, 24 MHz, and 32 MHz.
Caution Set the same value as 000C2H to 010C2H when the boot swap operation is used because
000C2H is replaced by 010C2H.
24.1.2 On-chip debug option byte (000C3H/ 010C3H)
{ Control of on-chip debug operation
• On-chip debug operation is disabled or enabled.
{ Handling of data of flash memory in case of failure in on-chip debug security ID authentication
• Data of flash memory is erased or not erased in case of failure in on-chip debug security ID authentication.
Caution Set the same value as 000C3H to 010C3H when the boot swap operation is used because
000C3H is replaced by 010C3H.
To Next Page
Loading...
