Renkforce RF2000 v2 Series - Page 109

109
Information messages
(AreeitherdisplayedintheprinterdisplayorinthelogleoftheRepetier-Hostsoftware)
Information:
Heat Bed Scan
Scan completed
Is displayed when the heat bed scan has been completed successfully.
Information:
Work Part Scan
Scan completed
Is displayed when the work piece scan has been completed successfully.
Information:
X-Axis
Min reached
IsdisplayedwhentheX-axiscannotbemovedbecausetheX-minhastripped.
Can be caused by:
-themenuitem"PositionX"
Information:
X-Axis
Max reached
IsdisplayedwhentheX-axiscannotbemovedbecausethemaximumX-positionisalreadyreached.
Can be caused by:
-themenuitem"PositionX"
Information:
Y-Axis
Min reached
IsdisplayedwhentheY-axiscannotbemovedbecausetheY-minhastripped.
Can be caused by:
-themenuitem"PositionY"
Information:
Y-Axis
Max reached
IsdisplayedwhentheY-axiscannotbemovedbecausethemaximumY-positionisalreadyreached.
Can be caused by:
-themenuitem"PositionY"
Error:
Z-Axis
Min reached
Is displayed when the Z-axis cannot be moved because the Z-min has tripped.
Can be caused by:
- the menu item "Position Z"
- the hardware button "up"
Error:
Z-Axis
Max reached
Is displayed when the Z-axis cannot be moved because:
- Z-max has tripped
- the maximum Z-position has been reached
Can be caused by:
- the menu item "Position Z"
- the hardware button "down"