Renkforce RF2000 v2 Series User Manual

27
Extruder
Temp. Bed: 0 °C Manually adjusting the heat bed temperature
Temp. 0 : 0 °C Manuallysettingtheextrudertemperatureextruder0(e.g.forlamentchange)
Temp. 1 : 0 °C Manuallysettingtheextrudertemperatureextruder1(e.g.forlamentchange)
Extruder 0 Off Switches off heater of the 1st extruder
Extruder 1 Off Switches off heater of the 2nd extruder
Active Extruder Specieswhichextruderisactive(pushOKtoswitch)
Position extruder Manually operate extruder infeed/1 mm per click/works only if the extruder is heated up
Load Filament Insertingthelament/extruderisheatedupautomatically,thenthelamentispulledin
Unload Filament Removingthelament/extruderisheatedupautomatically,thenthelamentismovedout
Set E Origin Set the new zero point
Fan Speed
Fan Speed: 0% Displays the current fan speed (0% - 100%)
Turn Fan off Switchesthefanoff;isonlydisplayedifthefanhasbeenswitchedonmanually
Fan to 25% Sets the fan speed to 25%
Fan to 50% Sets the fan speed to 50%
Fan to 75% Sets the fan speed to 75%
Fan to 100% Sets the fan speed to 100%
SD Card
Print File Start print from SD card
Delete File DeletelefromSDcard(thentheletobedeletedisselected)
Conguration
General Baud Rate: 115200 Setting of the transfer speed from the computer
Stepper off Time setting until the motors are switched off in standby
All off Time setting until the motors and heaters are switched off in standby
Beeper: On/Off Switches the button sound on or off
Mode: Printer/Miller Switches between the printer and mill modes
Z Scale: Z Min/Surface SpeciespointZ=0forthedisplayZ(5)inthemainmenu:
ZMin:speciesZ-Min,i.e.theZhomepositionaszeroposition
Surface:speciesthesurfaceoftheheatbedaszeroposition
Hotend: V3 Switches between the versions of extruders (the RF2000 v2 only supports the hotend V3)
ExtruderOffsetX SpeciesthedistancebetweenthetwoextrudersintheX-direction
(Standard=33.594;indicationinmm)
ExtruderOffsetY SpeciesthedistancebetweenthetwoextrudersintheY-direction
(Standard=0.000;indicationinmm)
Acceleration PrintX:1000 Setsthemax.printingaccelerationoftheX-axis
PrintY:1000 Setsthemax.printingaccelerationoftheY-axis
Print Z: 100 Sets the max. printing acceleration of the Z-axis
MoveX:1000 Setsthemax.travellingspeedoftheX-axis
MoveY:1000 Setsthemax.travellingspeedoftheY-axis
Move Z: 100 Sets the max. travelling speed of the Z-axis
X/Y-Jerk:10.0 Max.accelerationoftheXandYaxisatsmallsteps
Z-Jerk:0.1 Max. acceleration of the Z axis at small steps

Renkforce RF2000 v2 Series Specifications

General

Brand	Renkforce
Model	RF2000 v2 Series
Category	3D Printers
Language	English