Renkforce RF2000 v2 Series - Page 58

58
If you click "G-Code Editor" at the upper right, the G-code editor will open and the G-code (the layer description) will be displayed. The control
belowcaninuencethelayerview.
Preparation of the object to be printed for 2-coloured print
This section is only relevant for owners of the dual extruder version of the RF2000 v2.
Now select a setting with the ending "DUAL" for slicing in the "Printer Settings" (e.g. "GENERIC175_04_DUAL").
Forourexampleobject,thesamelamentsettingsshouldbechosenforbothextrudersaswell(e.g."RENKFORCE_PLA175_55_200").
The selection at "Print Setting" is identical for dual printing and single printing.
Click "Slice with RF2000v2",toslicethe3Dle.