Beijing RichAuto S&T Co., Ltd.
Forging ahead and determined to win 40
3) After read the file, press ― ‖the screen display line 1 of the code, press ― ‖,
prompted ―input start number: displays total lines‖, input number of start line and press
― ‖to confirm, if input wrong number, just press ― ‖ to delete it.
4) Press― ‖again, to set the end line, the screen displays ―input end number‖,
press― ‖the screen save the changed start line number, press ― ‖, Input end
line in cursor, press ― ‖ to confirm, press― ‖ to modify.
5) Set processing parameters.
5.6.5 Calculate bound
Calculate bound means user can check the size of processing, So as to avoid unnecessary
waste of materials and processing errors. Steps as below：
1) Press ― ‖ to enter, then press ― ‖ or― ‖to select file list;
2) Press ― ‖get into the file list, and then press ― ‖ or― ‖to choose file.
3) Press ― ‖, system start to read the file, after reading the file, the system will calculate
the area.
5.6.6 Mill plane
Include two types: scan mill and encircle mill.
1. Scan mill
Scan mill set
Scan type X Scan
Width 100.000
Height 100.000
Diameter 10.000
Depth 0.100
Z Step 0.100
T Ratio 0.800
To Next Page
Loading...
