Beijing RichAuto S&T Co., Ltd.
Forging ahead and determined to win 20
too much;if smaller, Z axis can’t touch workpiece. This parameter can only take effect when user
use auto toolsetting function.
9. Max Spd Limit（Max Speed Limit） Unit：mm/minute
Set machine top speed, it only takes effect during processing, system default max speed X,Y
is―60000000 mm/minute‖, ―Z+‖ is ―1800 mm/minute‖, ―Z-‖ is ―3000 mm/minute‖.
10. DistTime Limit Unit：second
Users select diatance mode,and if the machine does not move in a certain period of
time(system default is 30 seconds),the system will go back to continuous mode to prevent Z-axis
collision risk because of the customer forgot to switch back to continuous mode and set a large
distance value.
11. InputConfi（Input Port Configuration）
To open or prohibit input signal，if the interface board does not connect X5-X8 signals,users
can prohibit X5-X8 signals.
Setting：Press “ ”、“ ‖to move up and down，press“ ” to change
enable or disable,and then press“ ”to confirm.
4.2.2 AUTO PRO SETUP
Users can set the parameters about processing under‖AUTO PRO SETUP‖.
Auto Pro Setup chart
To Next Page
