RichAuto A1X - Page 26

Beijing RichAuto S&T Co., Ltd.
Forging ahead and determined to win 21
1. Work Speed Unit：mm/minute
Including work speed and fast speed,system default is 3000 mm/minute.
2. Safe Height Unit：mm
The height of Z axis rise during processing. System default is 40.000 mm.
3. Auto Scale
Actual processing speed=work speed*auto scale，system default auto scale does not affect the
fast speed.
4. Fall Scale
Fall scale，system default is 0.200.fall speed=fast speed*fall scale，the maximum fall speed is
Z axis negative limit speed*fall scale.
Fall height，system default is 5.000mm，fall down scale takes effect when the spindle falls to
the fall height.
5. Stop Statue
Setup stop position after auto processing.
(Coordnt=coordinate)
Set stop position：Press“ ”/“ ” to move cursor to where users want to
modify.Press ― ‖，input the new number，press ― ‖ to save.
Press“ ”to enter finish action list：
(FinAct=Finish Action，Org=Origin)
Work stop state
XCoordnt 0.000
YCoordnt 0.000
ZCoordnt 0.000
FinAct Pickup
FinAct
Back To Work Org
Back Home
Back Position
None move
Pickup Z