Beijing RichAuto S&T Co., Ltd.
Forging ahead and determined to win 35
Press ― ‖ and ― ‖ to move cursor, press ― ‖ to set the value (next value
setting is the same as this one), then pess ― ‖ to save, the system will check the processing
code and start to process when checking finished.
The system code checking is auto mode, user can press ― ‖ to skip the checking and
start ruuning file immidiately.
System will remenber the checking only when the previous checking is a complete and
correct checking.So that the system will not check the same code again next time.
In the process of processing, the screen scrolling display real-time processing speed,operation
time,current line number. We can switch these options by pressing ― ‖.
5.5 Operations during processing
5.5.1 Speed ratio & spindle grade Adjusting
1) Adjust speed ratio
In process of processing, press ― ‖、― ‖ can directly change speed ratio, current
speed= set speed * ratio, each push on ― ‖ or ― ‖, the speed ratio will go up or
dwon drop 0.1. Speed ratio:max 1.0, min 0.1, the displayed speed will corresponding to the
changing of speed ratio, but time will not change.
2) Adjust spindle grade
If user has set multistep speed, the DSP handle can change the multistep speed in process of
processing. Press ― ‖ and ― ‖ to change spindle grade.
Each push of ― ‖ and ― ‖ will go up or down drop 1 grade till to S8 or S1.
To Next Page
Loading...
