RichAuto A1X - Page 27

Beijing RichAuto S&T Co., Ltd.
Forging ahead and determined to win 22
Press“ ”/“ ” move cursor to where users want to modify，press ― ‖
to save.
6. G Code Setup
Set special G code attribute, according to the actual need to make changes.
（Ign=Ignore，Adj=Adjt=Adjust，AbsCntr= Absolute center）
CAUTION：Blue parts indicate system default attributes.
Setting：Press“ ”/“ ” move cursor to where users want to modify，press
“ ” to select the attribute users want，press ― ‖ to save.
7. Pro Attribute
Set some special settings about processing according to the actual need.
Setting：Press“ ”/“ ” move cursor to where users want to modify，press
“ ” to select the attribute users want，press ― ‖ to save.
Attribute Of G Code
F Read Ign F/Read F
AbsCntr Off/On
T Read Ign T/ Read T
Spindle NTLLG/FORCE/INSTR
FilterJD None/ Adj Z Filter
S Read Ign S/ Read S
Read G54 Ign G54/ Read G54
Read G49 Ign G49/ Read G49
Read G40 Ign G40/ Read G40
CodeHead Skip/NoSkip
Input TO -1
Work attribute
Adj Z Adj Z/Rev Z
Adjust WP None/Adjt
Ignore Z Read Z/ Ign Z
CirLmt 55.556
StepWork Contns/Single
ATC Spld Auto/None