System Service Mode
SM Appendix 9-249 D037/D038/D040/D041
Appendix:
SP Mode
Tables
5913 [Switchover Permission Time]
002
Print Application Timer *CTL
[3 to 30 / 3 / 1 second /step]
Sets the amount of time to elapse while the machine is in standby mode (and
the operation panel keys have not been used) before another application can
gain control of the display.
5967 [Copy Server Set Function]
*CTL
0: ON, 1: OFF
001
Enables and disables the document server. This is a security measure that
prevents image data from being left in the temporary area of the HDD. After
changing this setting, you must switch the main switch off and on to enable the
new setting.
5974
[Cherry Server]
Specifies which version of ScanRouter, “Lite” or “Full”, is installed.
001 Cherry Server *CTL
[0 or 1 / 0 / – ]
0: Lite
1: Full
5985
[Device Setting]
The NIC and USB support features are built into the GW controller. Use this
SP to enable and disable these features. In order to use the NIC and USB
functions built into the controller board, these SP codes must be set to "1".
001 On Board NIC
[0 to 2 / 0 / 1 /step]
0: Disable, 1: Enable, 2: Function limitation
When the "Function limitation" is set, "On board
NIC" is limited only for the NRS or LDAP/NT
authentication.
Other network applications such as NRS,
WebImageMonitor, or LDAP/NT
authentication are not available when this
SP is set to "2". Even though you can
Rev. 11/12/2009
To Next Page
Loading...
Need help?
General Specifications
