No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
[3003]
Check performed only when HDD is installed:
• HDD device busy for over 31 s.
•
After a diagnostic command is set for the HDD, but the device remains busy
for over 6 s.
• HDD defective
• HDD harness disconnected, defective
•
Controller board defective
[3004]
No response to the self-diagnostic command from the ASIC to the HDDs.
• HDD defective
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
823
CTL
B
Self-diagnostic error: NIB
[XXXX]: Detailed error code
[6101]
MAC address check sum error
The result of the MAC address check sum does not match the check sum stored in
ROM.
[6104]
PHY IC error
The PHY IC on the controller cannot be correctly recognized.
[6105]
PHY IC loop-back error
An error occurred during the loop-back test for the PHY IC on the controller.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
824
CTL
D
Self-diagnostic error: NIB
[XXXX]: Detailed error code
6. Troubleshooting
676
To Next Page
Loading...
