No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
877
CTL
B
SD card error
The 'all delete' function cannot be executed but DataOverwriteSecurity Unit is
installed and activated.
• Defective SD card
•
SD card not installed
1. Replace the NVRAM and then install the new SD card.
2. Check and reinstall the SD card.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
878
-00
CTL
D
TPM system authentication error
The system firmware is not authenticated by TPM (security chip).
• Incorrect updating for the system firmware
• Defective flash ROM on the controller board
1. Replace the controller board.
-01
D
USB Flash Error
File system in the USB flash device is defective.
• Cannot mount partition 3 in the USB flash device.
• Encryption key does not exist.
•
Cannot find the file for KMMD to be operated.
1. Replace the controller board.
-02 D
TPM Error
An error occurred in TPM or in TPM driver.
• TPM defective
1. Replace the controller board.
SC Tables
693
To Next Page
Loading...
Need help?
General
