7. Press the [Menu] key.
The initial screen appears.
• Confirm that the top of the stack is not higher than the limit mark on the side guides.
• Do not push the stack of envelopes with too much force.
• Confirm that the edges of envelopes fit under the side guides.
• p.88 "Types of Paper and Other Media"
Loading envelopes into the envelope feeder unit
The following explanation uses the example of installing the envelope feeder unit in "Tray 2".
• Even if the optional envelope feeder is not installed, you can select envelope sizes for Tray 2 using
the control panel. However, you cannot load envelopes until the optional envelope feeder unit is
installed.
• With the optional envelope feeder unit, you can load up to 60 envelopes at the same time.
• Confirm that the envelope flaps are securely folded down, and that there is no air inside the envelopes.
• Do not slide the paper tray in with force. If you do, the front and side guides might move.
1. Pull the optional paper feed unit (Tray 2) out until it stops. Then, lift it slightly, and then slide
it out.
To Next Page
Loading...
Need help?
General
