The top page of Web Image Monitor appears.
3. Click [Login].
The administrator can log on.
Enter the login user name and login password.
4. Click [Configuration], and then click [IPsec] under "Security".
The IPsec settings page appears.
5. Select [Active] for "Encryption Key Manual Settings".
6. Click [Edit] under "Encryption Key Manual Settings".
7. Set items for encryption key manual settings in [Settings 1].
If you want to make multiple settings, select the settings number and add settings.
8. Click [OK].
9. Select [Active] for "IPsec:" in "IPsec".
10. Set "Exclude HTTPS Communication" to [Active] if you do not want to use IPsec for HTTPS
communication.
11. Click [OK].
12. Click [Logout].
telnet Setting Commands
You can use telnet to confirm IPsec settings and make setting changes. This section explains telnet commands
for IPsec. To log in as an administrator using telnet, the default login user name is "admin", and leave the
password blank. For details about logging in to telnet and telnet operations, see “Remote Maintenance
by telnet”, Software Guide.
• If you are using a certificate as the authentication method in encryption key auto exchange settings
(IKE), install the certificate using Web Image Monitor. A certificate cannot be installed using telnet.
ipsec
To display IPsec related settings information, use the "ipsec" command.
Display current settings
msh> ipsec
Displays the following IPsec settings information:
• IPsec shared settings values
• Encryption key manual settings, SA setting 1-4 values
Transmission Using IPsec
365
To Next Page
Loading...
Need help?
General
