To Next Page

To Previous Page

IPsec SA (phase 2) PFS setting

msh> ipsec ike {1|2|3|4|default} ph2 pfs {none|1|2|14}

• Enter the separate setting number [1-4] or [default] and specify the IPsec SA (phase 2) Diffie-

Hellman group number.

• Specify the group number to be used.

• Not specifying a group number displays the current setting.

IPsec SA (phase 2) validity period setting

msh> ipsec ike {1|2|3|4|default} ph2 lifetime validity period

• Enter the separate setting number [1-4] or [default] and specify the IPsec SA (phase 2) validity

period.

• Enter the validity period (in seconds) from 300 to 172800.

• Not specifying a validity period displays the current setting.

Reset setting values

msh> ipsec ike {1|2|3|4|default|all} clear

• Enter the separate setting number [1-4] or [default] and reset the specified setting. Specifying

[all] resets all of the settings, including default.

Deactivating IPsec Using the Control Panel

1. Press the [Menu] key.

2. Press the [ ] or [ ] key to display [Host Interface], and then press the [ Enter] key.

3. Press the [ ] or [ ] key to display [Network Setup], and then press the [ Enter] key.

4. Press the [ ] or [ ] key to display [IPsec], and then press the [ Enter] key.

5. Press the [ ] or [ ] key to display [Not Active], and then press the [ Enter] key.

IPsec is now deactivated.

8. Security Measures Provided by this Printer

372

Ricoh CL4000DN Quick Installation Guide

Other manuals for Ricoh CL4000DN