11. Appendix
This section explains maintenance and operation procedures for this printer. It also describes the
specifications of the printer and it options.
Moving and Transporting the Printer
• When you move the printer, remember to unplug the power cord from the wall outlet to avoid
a fire or an electric shock.
• When you pull out the plug from the socket, grip the plug, not the cord, to avoid damaging
the cord and causing a fire or an electric shock.
• Repack the printer in its original packing materials for transporting.
• Be sure to disconnect all cables from the printer before transporting it.
• The printer is a precision piece of machinery. Take care to avoid damage during shipment.
• If the optional paper feed unit is installed, remove it from the printer, and then move them separately.
• The printer weighs approximately 17.5 kg (38.6 lb.).
Moving the Printer
• When lifting the machine, use the inset grips on both sides. Otherwise the printer could break
or cause an injury if dropped.
• Before moving the machine, unplug the power cord from the wall outlet. If the cord is
unplugged abruptly, it could become damaged. Damaged plugs or cords can cause an
electrical or fire hazard.
Moving the printer in a short distance
1. Be sure to check the following points:
• The power switch is turned off.
• The power cable is unplugged from the wall outlet.
• The interface cable is unplugged from the printer.
203
To Next Page
Loading...
Need help?
General
